Swift rivet machine manufacturer - rivet machine automatic process and operation method

The damage factors of automatic riveting machine are as follows:

< span> Belt deviation

Drum rubber wear and idler work improperly, which will affect belt deviation. In a fully automatic riveting machine, the belt offset high point is very firm, and the long work roller just wears out and thinns until it breaks. Before discharge, there is the amount of wear of the idler in the belt part.

< span> Belt return section attached to ash

Automatic riveting machine wiper blade wear, not close to the belt surface, ash viscosity increases, high moisture content will form the belt surface with slag surface, belt conveyor with slag pipe return section of the belt there is a vertical downward belt return section of the adhesive residue ash can be put into the dewatering tank, which is very different from the pipe belt conveyor plan arrangement.

3. High moisture content in ash

The buffer slag filter components and hydrophobic pipes are blocked, the sluice drainage pipe is blocked, and the water filter components are not washed in time after the automatic rivet machine is drained, which will lead to the ash carrying too much water.

4, buffer slag bin ash is straight

The ash produced by the slagging machine is not dehydrated during the defense time, but is transported directly to the dewatering tank via a tubular belt conveyor. Riveting machines will constitute more ash and water, pipe belt conveyor will increase idle time and accelerate idler, wear.

5, rivet machine bearing quality

The working face of some rollers is clean, because the doubt of bearing quality can also lead to changes in insensitivity or paper jams, and then wear.

6, the sealing performance of the riveting machine is poor

Slag is collected into the idler bearing, which can cause clogging or change sensitivity and cause wear.

7. Wear the fly ash to the roller

The ash from the slagging machine will simply adhere to the tape and fall onto the rollers and the rollers at both ends of the rollers. On the one hand, the roller body wears out, on the other hand, the roller body gathers to form a box.

8, the larger particle size of the ash remains on the roller body
Sometimes the larger ash from the slag extractor will adhere to the tape, and the hard and sharp material will quickly wear onto the roller.

9, the pipe belt mouth ash overflow

The idler roller of the roller set is worn, and the belt is transporting too much material, which will constitute the riveting machine. The belt is not tightly packed, the belt has a certain resonance, and the ash overflow at the mouth of the bag causes the wear of other rollers to accelerate.

Last：How to prevent the rivet machine operation process failure Next：The damage factors of [automatic riveting machine]

Swift rivet machine manufacturer - rivet machine automatic process and operation method

HOT article

Relevant news

Contact Us