Riveting machine manufacturers how to choose

< a href = "http://www.fxldj.com/ldqiang/168.html" > speed solid rivets pneumatic machine < / a > (self-priming automatic nailing machine) back light and beautiful and practical, with light weight, the hand feels comfortable, rivet small recoil, adopts pneumatic switch trigger structure of floating type, Compared with the traditional lever-type switch trigger structure, it is more labor-saving and can effectively reduce the fatigue of the user. The nail stroke is lengthened to meet the customer's use requirements in a wider range; The 360-degree air source joint is easy to use the riveting machine at any Angle, and the air source joint has a mesh on-off valve, sliding up and down to open or close the air source, labor saving and convenient: The product design is simple and easy to clean and maintain or repair. On the basis of the S50 model, the air circuit is improved to avoid the obstruction of the external lead pipe of the traditional self-priming rivet pulling machine body, and the napping is faster.
In the clamping device of the riveting machine, the front conduit of the three claws and the back conduit are connected through threads, and the flat position of the front conduit of the three claws and the back conduit are respectively fitted with the brake ring to fix the link between the two, eliminating the use of wrenches to install and disassemble.
The warranty period of the riveting machine is one year, of which the riveting machine head part is guaranteed for three months. If the use is found to be a manufacturing quality problem, the factory implements three guarantees. Artificial damage caused by violation of the use and maintenance regulations of the riveting machine is not included in the warranty.

Note: When riveting stainless steel nails, the working air pressure can not be lower than 6.5kgf/cm2.

2. The air source must be turned off when assembling and disassembling parts.
3. Before use, observe the end of the nail withdrawal hole of the rivet pulling machine to ensure that the jaw piece group is opened into a round hole state, and the five foreign objects in the nail withdrawal channel can be used normally.
4. The rear conduit should be completely screwed into the oil piston tube, and then locked with the lock nut in reverse rotation; The front and back pipes are also threaded and should be completely screwed in. If the brake ring bayonet cannot align with the clamp of the front and back pipes at the same time, the front pipe can be slightly rotated in the opposite direction to match the brake ring mouth.
Note: The front catheter should not be loosened more than one circle in the reverse direction.

Last：None Next：The nine factors that constitute the damage of the automatic riveting machine

Riveting machine manufacturers how to choose

HOT article

Relevant news

Contact Us